Ii2 - Curtis G3 D60 Series User Manual

INSTALLATION INSTRUCTIONS
WARNING:
WARNING: Improper electrical connection may result in an electric shock hazard or damage the unit. This
brewer must be properly grounded.
NOTICE: DO NOT connect this brewer to a hot water supply. The water inlet valve is not rated for hot water.
Do not exceed the maximum water pressure stated in the SPECIFICATIONS section.
IMPORTANT: Observe all governing codes and ordinances.
Installation Instructions
Installation Requirements
• A secure surface capable of supporting the weight of the appliance.
• For units without an attached cord set attached or dual voltage units set up for use with 220 - 240 Volts:
appliance will be hard wired to a junction box, the power cable must be long enough so that the unit can be
moved for cleaning underneath.
•
appliance (see SPECIFICATIONS). The circuit must be protected by the appropriate sized circuit breaker. If
you are not certain that the existing circuit meets the requirements for your unit, consult a licensed electrician.
•
•
SPECIFICATIONS section for the correct size. The water line should also be capable of being
controlled by a shut off valve. Do not connect the water line to a saddle valve or needle valve.
1 A quick disconnect or additional coiled tubing (at least two times the depth of the appliance) is required
so that it can be moved for cleaning underneath.
2
federal, state and local codes.
installed and maintained in accordance with federal, state and local codes.
the installation is in compliance with the applicable plumbing/sanitation code for your area.

II2