Installing/Replacing; Connecting Your Telephone To The Modem - Hitron CODA-4589 Manual To Installing/Replacing

Guide to installing/replacing
your Home Phone Hitron
CODA-4589 modem
Installing/replacing your Home Phone modem
3
Connecting the modem

Connecting your telephone to the modem

4
If you are not subscribed to Cogeco's Home Phone service, skip to step 5.
B
A
A
A. Locate a coaxial wall outlet. If you are using Cogeco's Wi-Fi service,
A
we suggest choosing an outlet that is centralized in your home for
the best possible Wi-Fi coverage.
Connect the coaxial cable provided from the wall outlet to the cable
B.
connector at the rear of the modem. Firmly hand-tighten the cables
to avoid damaging the connectors.
Connect the power cord to the modem and to an active electrical
C.
B
outlet. This will start the synchronization process. It can take up to
20 minutes for the modem to get online.
D. The online light on the front of your modem will blink green while it
is synchronizing. Once the process is complete, the online indicator
light will turn solid green.
E. If you do not see the correct indicator light pattern after 20
C
minutes, try moving your modem to another coaxial outlet in
your home and repeat the above process. For further support,
see the troubleshooting section at the end of this guide.
A.
If your phone uses an electrical power supply, ensure this is
connected to the base of your phone.
B.
Connect a telephone wire (not provided) from the base of your
phone, and connect the other end of the wire to the phone jack on
the back of the modem. The phone jack located at the top of the
modem is used for Line 1.
C. If you subscribe to 2 telephone lines, you can attach a second
telephone to the Line 2 phone jack.