Using I/O On The S7-400H - Siemens SIMATIC S7-400H Manual

Using I/O on the S7-400H

This chapter provides an overview of the different I/O configurations on the
S7-400H programmable logic controller and its availability. Further, it provides
information on configuration and programming of the selected I/O installation.
For the S7-400H you can use virtually any of the input/output modules featured in
the SIMATIC S7 system range. This applies to the input/output modules of the
S7-400 standard system and to the PROFIBUS-DP components. The function
modules (FMs) and communication processors (CPs) that can be used in the
S7-400H will be found in Appendix E.
In Section
7.1
7.2
7.3
7.4
7.5
Automation System S7-400H Fault-tolerant Systems
A5E00068197-07
Introduction
Using Single-Channel, One-Sided I/O
Using Single-Channel, Switched I/O
Connecting Redundant I/O
Other Ways of Connecting Redundant I/O
Description
7
On Page
7-2
7-3
7-5
7-10
7-35
7-1