Assembling And Installing; Step 1 : Assemble The Stand ~ Mount The Machine - Roland SOLJET Pro 4 XF-640 Setup Manual

3. Assembling and Installing

Step 1 : Assemble the Stand ~ Mount the Machine ~

WARNING
CAUTION
Procedure

Attach the stand legs to the stand stay.
Place the stand legs with its horseshoe-shaped bracket facing inside, and secure them by tightening the
bolts in the order given below. (8 locations in total) Loose bolts may cause the stand to wobble.
Lightly tighten the bolts in the upper 2 locations (4 locations in total for right and left).
Lightly tighten the bolts in the 2 locations on the side (4 locations in total for right and left).
Fully tighten the bolts in the upper 2 locations (4 locations in total for right and left).
Fully tighten the bolts in the 2 locations on the side (4 locations in total for right and left).
Tighten
temporary
Tighten
fully
Bolts : 8
Washer: 4
Place the leg with the horseshoe-shaped
bracket facing inward.
Place the stand stay as shown in the figure below.
22
Perform this task with all power switches left switched off.
Otherwise sudden movement of the machine may cause injury.
Unpacking and installation must be carried out by six or more persons.
Otherwise the machine or the stand may fall, resulting in injury.
Hexagonal wrench
Bolts
Stand leg
Side view
Make this area
equally spaced.
Stand leg
Hexagonal wrench
Bolts
Stand stay
Stand stay
Stand leg
Washer
Top view
Align them parallel
to each other.
Stand stay