Table of Contents
Advertisement
Figure 25
1. Hairpin cotter
2.
Secure the assembly to the hitch receiver using
the hitch pin and hairpin cotter attached to the
receiver
(Figure
25).
3.
Pull out the kickstand locking pins on both sides
of the machine, rotate them 90 degrees so that
they are disengaged, and raise the kickstand
(Figure
26). Engage the knobs and ensure that
the pins snap into position.
Figure 26
1. Kickstand locking pin in
the engaged position
2. Kickstand locking pin in
the disengaged position
g230770
2. Hitch pin
g230843
3. Kickstand in the blower
operating position
4. Kickstand in the blower
storage position
Removing the Blower
1.
Park the machine on a level surface, disengage
the PTO, engage the parking brake, and
move the motion-control levers outward to the
N
-L
EUTRAL
OCK
2.
Shut off the engine and remove the key.
3.
Disconnect the blower hydraulic hoses from the
quick-disconnect couplings on the Low Flow Kit.
4.
Lower the blower; refer to
(page
12).
5.
Remove the belt from the clutch.
Note:
If needed, use a drive ratchet (1/2 inch)
to move the left idler pulley
1. Drive ratchet
6.
Lift the blower assembly off the bushing
assemblies on the machine.
14
position.
Lowering the Blower
(Figure
27).
Figure 27
2. Pulley
g231579
Advertisement
Table of Contents
