Table of Contents
Advertisement
Installing the blade appliance
To install the blade appliance, complete the following tasks.
1. Make sure that the expansion unit is installed (see "Installing the expansion
2. Install the blade appliance into the BladeCenter unit (see "Installing the blade
3. Turn on the blade appliance (see "Turning on the blade appliance" on page
4. If this is the first time you are installing the blade appliance, you will need to
Installing the expansion unit
Use these instructions to install the expansion unit.
The expansion unit is required for the IBM WebSphere DataPower Integration
Blade XI50B appliance to operate.
To install the expansion unit, complete the following steps.
1. Before you begin, read "Safety statements" on page vii and "Installation
2. Orient the expansion unit as shown in the illustration.
3. Lower the expansion unit so that the slots at the rear slide down onto the cover
unit" for information on installing the expansion unit).
Statement 21
CAUTION:
Hazardous energy is present when the blade server is connected to the power
source. Always replace the blade server cover before installing the blade
server.
appliance in a BladeCenter unit" on page 16).
12).If you have just connected the power cords of the BladeCenter unit to
electrical outlets, you must wait until the power-on LED on the blade appliance
flashes slowly before you press the power-control button.
configure it (see Chapter 4, "Setting up the initial firmware configuration," on
page 21).
Expansion unit
Expansion
unit release
Expansion
unit release
guidelines" on page 13.
pins at the rear of the blade appliance.
Chapter 3. Installing and removing the blade appliance
15
Advertisement
Table of Contents
