Advertisement
Quick Links
Deck Limit Kit
2014 and Before Groundsmaster
Model No. 130-6020
This kit fits on models 30603, 30605, 30607, and 30609.
Note: Determine the left and right sides of the machine
from the normal operating position.
This product contains a chemical or chemicals known to the State of California to
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
1
Preparing the Machine
No Parts Required
Procedure
Position the machine on a level surface, set the parking brake,
lower the cutting units, turn the ignition off, and remove the
key.
© 2015—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Proposition 65 Warning
cause cancer, birth defects, or reproductive harm.
Description
No parts required
Axle bumper
Left bumper bracket
Right bumper bracket
Locknut
Bolt (#10 x 1-1/4 inch)
Bolt (#10 x 2 inch)
Washer
Bumper
Plate
Locknut
Register at www.Toro.com.
®
4000/4010 Rotary Mower
WARNING
CALIFORNIA
Qty.
–
2
1
2
2
4
4
8
4
8
4
CAUTION
If you leave the key in the ignition switch, someone
could accidently start the engine and seriously
injure you or bystanders.
Remove the key from the ignition switch before you
do any maintenance.
Form No. 3393-700 Rev A
Installation Instructions
Use
Prepare the machine.
Install the axle bumpers and bumper
brackets.
Install the plates and bumpers.
Original Instructions (EN)
All Rights Reserved *3393-700* A
Printed in the USA.
Advertisement
Related Manuals for Toro 130-6020
Summary of Contents for Toro 130-6020
- Page 1 Deck Limit Kit 2014 and Before Groundsmaster ® 4000/4010 Rotary Mower Model No. 130-6020 Installation Instructions This kit fits on models 30603, 30605, 30607, and 30609. Note: Determine the left and right sides of the machine from the normal operating position.
- Page 2 2. Install an axle bumper onto the left bumper bracket and secure with a locknut (Figure 3. Use the existing hardware you removed to attach the bracket to the machine (Figure Installing the Axle Bumpers and Bumper Brackets (Cab Machines Only) Parts needed for this procedure: Axle bumper Left bumper bracket...
- Page 3 2. Install the plates and kit bumpers onto the machine as shown in Figure Installing the Plates and Bumpers Parts needed for this procedure: Bolt (#10 x 1-1/4 inch) Bolt (#10 x 2 inch) Washer Bumper Plate Locknut Procedure Figure 4 1.