Advertisement
6. Remove the hairpin cotter securing the rear cushion
bracket (Figure 4).
7. Slide the bushing next to the machine (Figure 4).
8. Lower the rear cushion bracket onto the platform
(Figure 4).
1
1. Hairpin cotter
2. Bushing
9. Route the light kit wire harness in front of the control
cables and near the traction unit wire harness.
10. Plug the wire harness into the lights (Figure 5).
Note: The right light has a 2-wire connector and
the left light (with the button switch) has a 3-wire
connector.
2
3
g018322
Figure 4
3. Rear cushion bracket
1
1. 2-wire connector
2. Wire harness
11. Route the wire harness down to the fuse block.
12. Locate the short connector behind the fuse block and
remove the insulator cap from the connector.
3
Figure 5
3. 3-wire connector
Advertisement
