Advertisement
13.
Install the Y-adapter.
•
Plug the single end of the Y-adapter into the short
connector behind the fuse block (Figure 6).
•
Plug the wire harness for the lights into the other
end of the Y-adapter (Figure 6).
•
Plug the wire harness for the Hydraulic Cooling
Assembly (if present) into the Y-adapter (Figure 6).
5
1. Wire harness for either
the Lights or the Hydraulic
System Cooling Assembly
2. Wire harness for either
the Lights or the Hydraulic
System Cooling Assembly
3. Y-adapter
14. Install the fuse (Figure 7).
6
1
Figure 6
4. Short connector behind
the fuse block
5. Fuse box
6. Main wire harness
6
4
1. Fuse
3
15. Secure the Y-adapter to the main wire harness with a
wire tie supplied in the kit.
Note: Position the Y-adapter so that the fuses are in
an upright position (Figure 6).
16. Secure the light kit wire harness to the traction unit
with 3 plastic ties supplied in the kit.
2
17. Install the rear cushion (Figure 4).
18. Install the negative (-) battery cable to the battery.
g018573
Operation
Operating the Lights
Note: The lights can only be on when the ignition switch
is in the Run position.
1. With the ignition switch in the Run position, turn the
lights on or off by depressing the button switch on the
left light.
2. Pivot or swivel the lights to the desired position.
4
1
g018576
Figure 7
Advertisement
