Pin Assignment - Siemens SIMATIC TDC System Manual

Interface module
7.1 Interface module SB10
7.1.4

Pin assignment

Ribbon cable connector X1
The cables SC62 or SC66 are used to connect the interface modules to the SIMATIC TDC
components (for more information, refer to the SIMATIC TDC Documentation).
Terminal block X2
Table 7- 1
Conductor cross-section
The minimum conductor cross-section for the terminal block X1 is 0.2mm² and the maximum
is 2.5 mm².
162
Pin assignment of the digital I/O of interface module SB10
Terminal
1 Channel 1 (digital input/output 1)
2 Channel 2 (digital input/output 2)
3 Channel 3 (digital input/output 3)
4 Channel 4 (digital input/output 4)
5 Channel 5 (digital input/output 5)
6 Channel 6 (digital input/output 6)
7 Channel 7 (digital input/output 7)
8 Channel 8 (digital input/output 8)
51 Reference busbar, 1M (1P can be set)
52 Reference busbar, 1M (1P can be set)
53 Reference busbar, 1M (1P can be set)
54 Reference busbar, 1M (1P can be set)
55 Reference busbar, 1M (1P can be set)
56 Reference busbar, 1M (1P can be set)
57 Reference busbar, 1M (1P can be set)
58 Reference busbar, 1M (1P can be set)
Designation
System Manual, 12/2013, A5E01114865-07
SIMATIC TDC hardware