Ez Lock Operating Instructions - Dremel Lite 7760 Operating/Safety Instructions Manual

1600A01A91.qxp_7760 3/4/19 1:55 PM Page 26
EZ Lock™ Mandrel No. EZ402 has a spring
loaded sleeve and is used with cutting
wheels, abrasive buffs and polishing cloth.
disconnect the plug from the power source
or the battery pack from the tool before
changing accessories. Such preventative
safety measures reduce the risk of starting
the power tool accidentally.
Always make sure accessory is properly
seated on mandrel before use. Incorrect
seating of accessory on mandrel may lead to
personal injury or property damage.
To load accessory:
1. Place EZ Lock™ mandrel into collet as
deep as possible and tighten collet nut.
Note: There is a blue spacer that will
bottom out on the collet nut, setting the
mandrel to the correct depth. When using
with Dremel chuck, back the mandrel out
slightly before tightening.
2. Pull spring-loaded sleeve DOWN towards
tool with one hand and hold. You can
brace the tool on the body or work-bench
for extra leverage (Fig. 1).
3. With the other hand, align bowtie shape
on cut-off wheel with mandrel and make
sure metal insert is facing away from the
tool (Fig. 2).
4. Place wheel on the mandrel to a point
just below the bowtie on the mandrel and
twist 90 degrees until the bowtie shape
on the wheel aligns with the sleeve.
Release sleeve. Wheel should lock in
place (Fig. 3).
5. When mounting sanding and polishing
accessories, align bowtie with metal
insert on bottom of accessory (Fig. 4 & 5).
To check for proper seating, hold shaft
lock button and
Accessory will not be able to rotate on
mandrel.
To unload accessory:
1. Pull spring-loaded sleeve DOWN toward
tool with one hand (Fig. 1).
2. Hold sleeve down while twisting
accessory 90 degrees.
3. Remove accessory.
During use
Avoid damage to EZ lock™ mandrel by not
letting it contact the workpiece.
EZ Lock™ Operating Instructions
Always make sure the
rotary tool is "OFF" and
twist accessory.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
26