Protecting The Environment; Maintenance - DeWalt DWS520 Original Instructions Manual

Type of Material to be Cut
Solid wood (hard, soft)
Chipboards
Laminated wood, blockboards, veneered and
coated boards
Paper and carton
Wall Cutting (Fig. A, G)
1. Place the plunge saw with the outer guard
flat floor.
2. Press the shoe 4 with the front side on the door against the
adjusted depth stop.
Dust Extraction (Fig. A)

WARNING: Risk of dust inhalation. To reduce the risk of
personal injury, ALWAYS wear an approved dust mask.
Your tool is fitted with a dust extraction outlet
The Dust Extraction Adapter allows you to connect the tool to
an external dust extractor, either using the AirLock™ system
(DWV9000-XJ), or a standard 35 mm dust extractor fitment.

WARNING: ALWAYS use a vacuum extractor designed
in compliance with the applicable directives regarding
dust emission when sawing wood. Vacuum hoses of most
common vacuum cleaners will fit directly into the dust
extraction outlet.

MAINTENANCE

Your D WALT power tool has been designed to operate
e
over a long period of time with a minimum of maintenance.
Continuous satisfactory operation depends upon proper tool
care and regular cleaning.

WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from power
source before making any adjustments or removing/
installing attachments or accessories. Be sure the
trigger switch is in the OFF position. An accidental start-up
can cause injury

WARNING: If the saw blade is worn replace it with a new
sharp blade..
Lubrication
Your power tool requires no additional lubrication.
Cleaning

WARNING: Blow dirt and dust out of the main housing
with dry air as often as dirt is seen collecting in and around
the air vents. Wear approved eye protection and approved
dust mask when performing this procedure.

WARNING: Never use solvents or other harsh chemicals
for cleaning the non-metallic parts of the tool. These
chemicals may weaken the materials used in these parts.
Use a cloth dampened only with water and mild soap.
Never let any liquid get inside the tool; never immerse any
Speed Range
part of the tool into a liquid.
3–5
Optional Accessories
4–5

WARNING: Since accessories, other than those offered
2–5
by D
of such accessories with this tool could be hazardous.
1–3
To reduce the risk of injury, only D
accessories should be used with this product.
Consult your dealer for further information on the
on a clean,
22
appropriate accessories.

Protecting the Environment

be recovered or recycled reducing the demand for raw
9 .
materials. Please recycle electrical products and batteries
according to local provisions. Further information is available at
www.2helpU.com.
WALT, have not been tested with this product, use
e
Separate collection. Products and batteries marked
with this symbol must not be disposed of with normal
household waste.
Products and batteries contain materials that can
English
WALT recommended
e
11