Battery installation (for power
backup)
You can insert 8 AA (LR6) batteries (not
supplied) into the camera base to temporarily
power the camera in the event of a power
failure.
Please install the batteries before a power
failure occurs.
Important:
• Use only alkaline batteries.
• Do NOT use manganese Ni-Cd, Ni-MH
Lithium, or Lithium ion batteries
• Confirm correct polarities (+ , - ).
• Batteries are only intended for short-term use.
Once the batteries are installed, the AC
adaptor should be used as the power source
for the camera.
1 Open the camera base cover.
2 Install the batteries in the battery holder.
3 Close the camera cover.
Note:
• The HomeHawk app notifies you when the
battery power is low or when the battery
is out of power. In this case, remove and
replace all of the batteries with new ones.