Table of Contents
Advertisement
Installing hull unit on retraction tank
After welding the retraction tank and allowing sufficient time for cooling, install the hull unit
as follows:
1. Clean the hull unit flange, the O-ring and O-ring groove and coat them with a slight amount
of grease. Place the O-ring in position on the tank flange.
2. Lay the gasket (1) on the top of the tank flange.
3. Orient the hull unit so that the bow mark (arrow) on its flange points toward the ship's bow.
Note that heading adjustment in the display unit is required if the bow mark does not face
the ship's bow.
4. For the 1200 mm transducer travel type. 7 of the 16 bolt holes on the hull unit flange have
already been fitted with bolts. Insert the gasket (2) into the bolt holes of the tank flange to
which these eleven bolts are fitted. Note that it is difficult to fit them after the hull unit has
been placed on the tank.
5. Confirm that the O-ring and the gasket (1) are in position. Place the hull unit on the tank.
6. Coat every bolt, washer and nut with slight amount of grease to ease removal. Fit the insu-
lation gasket (2) into the bolt holes of both the tank and hull unit flanges. Fasten the hull unit
to the retraction tank with gasket (2), flat washers, spring washers and hex bolts. (Insulation
gasket (2) and gasket (2) are used on the 1200 mm transducer travel type only.)
7. Reinforce the hull unit against vibration by extending stays to the ship's hull from the two
eye bolts at the top of the hull unit, referring to figure at the top of the next page.
Hex Bolt
Flat Washer
Gasket (2)*
Insulation Gasket (2)
Hull Unit Flange
Gasket (1)
O-ring
Tank Flange
Insulation Gasket (2)*
Gasket (2)*
Flat Washer
Spring Washer
Hex Nut
*
Figure 3-4 Installation of hull unit
7
Hex Nut
Flat Washer
Gasket (2)*
Gasket (1)
Insulation Gasket (2)*
Gasket (2)*
Flat Washer
Spring Washer
Hex Nut
* Used only on 1200 mm
travel type.
Advertisement
Table of Contents
