To Start A Cold Engine - Husqvarna 555FX Operator's Manual

20
US gallon
1
2 1/2
5
CAUTION: Small errors can influence the
ratio of the mixture drastically when you mix
small quantities of fuel. Measure the quantity
of oil carefully and make sure that you get
the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION: Do not mix fuel for more than 1
month at a time.
To fill the fuel tank
1. Clean the area around the fuel tank cap.
2. Shake the container and make sure that the fuel is
fully mixed.
3. Remove the fuel tank cap and fill the fuel tank.
4. Tighten the fuel tank cap carefully.
1346 - 002 - 08.10.2019
5. Move the product 3 m/10 ft or more away from the
0.40
US fl. oz.
2 ½
Note: To see where the fuel tank is on your product,
refer to
6 ½
Work position
12 ⅞
•
•
•
•
•
•
Correct balance of the product
For forestry clearing, the product is correctly balanced
when it freely hangs horizontally from the suspension
point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.

To start a cold engine

1. Set the stop switch to the start position.
refueling area and fuel source before you start the
engine.
Introduction on page 2 .
Hold the product with 2 hands.
Hold the product on the right side of your body.
Keep the cutting attachment below waist level.
Always keep the product attached to the harness.
Keep body parts away from the hot surfaces.
Keep body parts away from the cutting attachment.
17