Dismantling.the.front.handle.and.start.inhibitor.-.Lihd60X./.Lihd70X - Husqvarna LiHD50 Workshop Manual

Table of Contents

Advertisement

8.7 Dismantling the front handle and
start inhibitor - LiHD60X / LiHD70X
1
Dismantle the front handle and the right chassis
half.
See Chapter 7.5 - 7.6.
2
Dismantle the gear housing and motor.
See Chapter 10.2.
3
Uncouple the handle cables (A) from the control
unit and remove them through the hole (B) in the
chassis.
See figure 7.
WARNING!
Exercise care to ensure the spring
does not fly out and causes person-
al injury. Wear protective goggles!
4
Loosen the screws (10x) and carefully lift off the
handle half.
See figure 8.
5
Lift the relay with cables (C) and the loop (D) out of
the handle.
See figure 9.
6
Lift the start inhibitor (E), plastic clips (F 3x),
springs (G 3x) and spring (H) over the screw tower
out of the handle.
See figure 10.
A
B
Fig.7
Fig.8
C
Fig.9
F
G
H
E
G
F
Fig.10
Safety equipment
D
G
F
English
29

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lihd60xLihd70x

Table of Contents