Putting the AC 3200-II into operation
Putting the AC 3200-II into operation
Preparing the AC 3200-II for use
You can set up the AC 3200-II on an even surface or mount it into a rack�
Setting up the device
CAUTION
DANGER OF HEAT DAMAGE TO THE DEVICES
During operation, the AC 3200-II and the connected transmitters produce
considerable waste heat� If this heat cannot dissipate, it can cause damage to
the devices�
The devices are equipped with fans to assist dissipation of generated heat:
Make sure that the air vents
or blocked and provide ducts of sufficient size or allow sufficient space to
ensure a free air flow between the devices�
Regularly clean the air vents on the sides of the AC 3200-II with a soft brush�
In order to avoid heat accumulation, make sure to install the AC 3200-II as
the uppermost device�
Never stack more than two devices directly one above the other�
Never place several NT 12-125D mains units directly next to or on top of one
another�
To ensure that the AC 3200-II cannot slip on the surface on which it is placed,
four self-adhesive soft rubber feet are supplied�
CAUTION
RISK OF STAINING OF SURFACES
Some surfaces have been treated with varnish, polish or synthetics which
might cause stains when they come into contact with other synthetics� Despite
a thorough testing of the synthetics used by us, we cannot rule out the possi-
bility of staining�
Do not place the AC 3200-II on delicate surfaces�
22 | AC 3200-II
on the sides of the AC 3200-II are not covered
2