Philips HR7725/60 User Manual page 8

Tips:
• Liquid ingredients (for example oil for
making mayonnaise) can be poured into
the blender jar through the hole in the
36
stopper which has been put in the lid
upside down (fig. 36).
• The opening in the lid can be used to add
ingredients while the appliance is running.
To do so, unscrew the stopper and remove
2
it from the lid (fig. 37-38).
• The longer you let the appliance run, the
finer the blending result will usually be.
37
• It may be necessary to switch off the
appliance from time to time to remove
1
pieces of food sticking to the inside of the
blender jar.
- Switch off the appliance and unplug it;
- Remove the stopper and the lid;
- Remove pieces sticking to the inside of the
blender jar with a soft spatula. Keep the
spatula at a safe distance from the knives
38
(approximately 2 cm).
Cleaning
• Always unplug the appliance before you
start cleaning the motor unit.
• You can clean the motor unit with a damp
cloth. Do not immerse the motor unit in
water and do not rinse it either.
• Always clean the parts that have come into
contact with food in hot water with
washing-up liquid immediately after use.
• Clean the blade, the knife unit of the
blender and the slicing disc very carefully.
The cutting edges are very sharp!
• Make sure that the cutting edges of the
blade and the slicing disc do not come into
contact with hard objects: this could cause
39
1
2
40
3
41
9
them to become blunt.
• The gearwheels of the beater can be
detached and cleaned very easily
(fig. 39-40).
• Certain ingredients may cause
discolorations on the surface of the
accessories. This does not have a negative
effect; the discolorations usually disappear
after some time.
• Wrap the (excess) mains cord around the
reel on the back of the appliance (fig. 41).