Table of Contents
Advertisement
PAMS
Technical Documentation
Component Parts
Mounting Bracket MBE–2
The mounting bracket MBE–2 shall be installed using three screws. The
bracket itself can to a certain degree compensate for unevenness of the
mounting surface. However, should additional spacers be required, two
different types are supplied with the bracket.
The transceiver may be installed in the bracket in two ways: either by slid-
ing the transceiver into the bracket or by vertically inserting the transceiver
from the top.
Handset Cradle CRD–8
The cradle CRD–8 acts as a holder for the handset. The cradle is at-
tached to the vehicle interior using the mounting plate or swivel mount
HHS–9.
Mounting Plate and Swivel Mounting Plate HHS–1
This is a fixed position mounting plate; HHS–1 is a swivel mounting plate
which allows adjustable fixing of the CRD–8 cradle. Both mounting plates
are interchangeable.
System Cable SCM–5 and Vehicle Installation Cable DKS–7
The system cable connects the phone to the vehicle supply and accesso-
ries.
The power wires red (+) and black (–) shall be routed to the battery itself
(alternatively to the main distribution point of the vehicles fuse box) both +
and – must be fuse protected (3 A).
The blue ignition sense (IGNS) wire is connected to +12 V voltage con-
trolled by the vehicle's ignition key via 1A fuse. The ignition sense can uti-
lize voltages up to 24 V, see section "Ignition Sense"
The yellow wire is used for car radio muting (XCRM). The line goes down
to 0 volts during a call. The maximum sink current is 100 mA, hence the
actual muting operation may have to by done using an auxiliary relay, or a
muting unit provided by the manufacturer, see "Car Radio Muting".
The orange wire is used for motor antenna (ANTC). The voltage in this
output is +12 V whenever the phone is on. The maximum sink current is
180 mA, so the actual motor antenna operation may have to be done by
using an auxiliary relay, see "Power Antenna Control".
The RJ45 handset connector is non–assembled. Locate the correct posi-
tion, fasten the bottom shell with two screws, place the connector and
cable and click the top on.
Issue 1 10/99
NME–3
Installation instructions
Page 5
Advertisement
Table of Contents
