PAMS
Technical Documentation
Power Antenna Control (ANTC)
The orange wire of the system cable (ANTC) may be used to control dif-
ferent devices on and off. The voltage in this output is +12 V whenever the
phone is on. If the phone is turned off, the voltage disappears. The maxi-
mum output current is 180 mA, therefore for example motorized antenna
must be controlled via a relay, see picture below.
Supply for de vice
From ANTC line
(orange wire)
Fuse 180 mA
(
not supplied)
Testing
Once installed, the equipment should be tested to ensure that it is operat-
ing satisfactorily and that the position of the units does not impair on the
driver's ability to control and operate the vehicle in any way.
Use the phone to make a call when the vehicle is parked with the engine
running. During the call, switch off the engine. Ensure that the phone is
operational with the engine running and with the engine switched off. For
operating information refer to the 'User Guide' supplied with the phone.
Issue 1 10/99
Bosch P/N 0–332–204–150 12
V, 30 A. SPDT
Figure 4. Connection – Power Antenna Control
NME–3
Installation instructions
CONTROLLED
DEVICE, e.g.
MOTOR ANTENNA
Page 11