Component Parts; Mounting Bracket Mbe-2; Handset Cradle Cre-1; Mounting Plate Mke-1 And Swivel Mounting Plate Hhs-1 - Nokia NME-2A Series Installation Instructions Manual

P.A.M.S.
Technical Documentation

Component Parts

Mounting Bracket MBE–2
The mounting bracket MBE–2 shall be installed using three screws. The
bracket itself can to a certain degree compensate for unevenness of the
mounting surface. However, should additional spacers be required, two
different types are supplied with the bracket.
The transceiver may be installed in the bracket in two ways: either by
sliding the transceiver into the bracket or by vertically inserting the
transceiver from the top.
Handset Cradle CRE–1
The cradle CRE–1 acts as a holder for the handset. The cradle is attached
to the vehicle interior using mounting plate MKE–1 or swivel mount
HHS–1.
Mounting Plate MKE–1 and Swivel Mounting Plate HHS–1
MKE–1 is a fixed position mounting plate; HHS–1 is swivel mounting plate
which allow adjustable fixing of the CRE–1 cradle. Both mounting plates
are interchangeable.
System Cable SCM–1/SCM–3 and Vehicle Installation Cable DKS–3
The system cable connects the phone to the vehicle supply and
accessories. The long System Cable SCM–3 is optional.
The power wires red (+) and black (–) shall be routed to the battery itself
(alternatively to the main distribution point of the vehicles fuse box) both +
and – must be fuse protected (3 A).
The blue ignition sense (IGNS) wire is connected to +12 V voltage
controlled by the vehicle's ignition key via the supplied fused connector.
The ignition sense can utilize voltages up to 24 V, see section "Ignition
Sense"
The yellow wire is used for car radio muting (XCRM). The line goes down
to 0 volts during a call. The maximum sink current is 250 mA, hence the
actual muting operation may have to by done using an auxiliary relay, or a
muting unit provided by the manufacturer, see "Car Radio Muting".
The orange wire is used for motor antenna (ANTC). The voltage in this
output is +12 V whenever the phone is on. The maximum sink current is
200 mA, so the actual motor antenna operation may have to be done by
using an auxiliary relay, see "Power Antenna Control".
The RJ45 handset connector is performed by non–assembled. Locate the
correct position, fasten the bottom shell with two screws, place the
connector and cable and click the top on.
Original 08/97
NME–2A
Installation Instructions
Page 7