Avaya E169 Manual page 36

Initial setup and connectivity
Procedure
1. Install the tablet bracket by gently rotating the bracket into position until you feel the bracket
snap into position.
Important:
If you cannot push the power button or the bracket is not slanted, you did not install the
bracket in the correct position. When removing the tablet bracket, grasp the bracket from
the corners and gently rotate the bracket up and away from the media station. If you try
to pull the tablet bracket straight out, you might damage the bracket.
2. Perform one of the following actions:
• To install a tablet in a position where the USB cable power connector is pointing down into
the bracket, route the USB cable through the tablet bracket and set the tablet on the
bracket.
• To install a tablet in a position where the USB power connector is not pointing down into
the bracket, connect the USB cable of the device to the tablet and set the tablet in position
on the bracket. This position is also useful if you plan to hold the tablet by hand on
occasion.
Installing and Maintaining the Avaya E169 IP Media Station
36
Comments? infodev@avaya.com
June 2014