Avaya E169 Manual page 32

Initial setup and connectivity
• For devices that use an Apple 30-pin cable, insert the cable as shown in the figure with
the side that has the raised key on the connector facing up. Slide the connector into the
sleeve. The connector will not slide into the sleeve if you have the raised key facing down.
• For devices that use a micro USB cable, insert the cable as shown in the figure with the
shorter-width side of the connector facing up. Slide the cable into the sleeve.
2. Insert the cable sleeve into the slot from the top of the media station.
Warning:
Ensure that you place the sleeve as shown in the following diagram. If you insert the
sleeve the wrong way, the sleeve might get stuck in the media station.
Installing and Maintaining the Avaya E169 IP Media Station
32
Comments? infodev@avaya.com
June 2014