Table of Contents
Advertisement
im Vertrieb von
www.camboard.de
CAMBOARD Electronics
•
1360 x 765 (plasma) at 60 Hz, and lock*
•
1365 x 1024 (plasma) at 60 Hz, and lock*
•
1400 x 1050 (SXGA+) at 50 Hz, 60 Hz, and lock*
•
576p (Progressive PAL) at 50 Hz, and lock*
•
720p (HDTV) at 50 Hz, 60 Hz, and lock*
•
1080p (HDTV) at 50 Hz, 60 Hz, and lock*
•
1080i (HDTV) at 50 Hz, 60 Hz, and lock*
* See Accu-RATE Frame Lock
• Power supply — Includes an internal, 100–240 VAC, 50/60 Hz,
autoswitchable power supply.
• RS-232 control — Provides control for third-party remote control of features
and functions that can be programmed by using Extron's SIS™ (Simple
Instruction Set™) or Extron's control software for Windows. The RS-232 port
also provides communication between the SGS 408 and an Extron ECP 1000
event control panel.
• RCP port — Supports an Extron RCP 1000, which allows the switch operator
to control the switcher from a remote location.
• Transitions — Control the type of switch that will occur between the preview
and program outputs. The cut button creates an instant switch between
the preview and program outputs. The effect buttons allow the switcher
operator to choose from among four predefined effects.
• Accu-RATE Frame Lock
TM
which is associated with scaling, especially when motion video is
involved, and occurs when the input frame rate is slower or faster than the
output frame rate and part of the old frame and part of the new frame are
displayed at the same time during a refresh cycle. The Extron Accu-RATE
Frame Lock sets and locks the output frame rate to the input frame rate of a
designated input and produces a tear-free output in a seamless switching
system.
• Centering and sizing — Allow the output to be centered or sized, both
horizontally and vertically.
• Brightness and contrast controls — Adjust the brightness and contrast of an
input.
• Horizontal and vertical filtering — Provides up to eight levels of horizontal
and eight levels of vertical filter control. These operator-selectable filtering
controls ensure image sharpness and ensure that no picture detail is
dropped.
• Test patterns — Allow the switcher operator to determine whether the
switcher is set up properly before an image is available. The test patterns
also help with projector setup.
Tel. 07131 911201
Fax 07131 911203
below.
TM
(AFL
TM
) — Eliminates the image tearing problem
ce-info@camboard.de
SGS 408 Switcher • Introduction
1-3
Advertisement
Table of Contents
