Toro 99-8515 Installation Instructions

Loose Parts
Note: Use the chart below to identify parts for assembly.
DESCRIPTION
Flat washer
Hex Head Screw
Hex Lock Nut
Spacer
Spring
Installing engagement kit
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to
"OFF" to stop the engine. Remove the key.
2. Remove existing hardware from blade
engagement lever. Discard old hardware.
Note: You may have to loosen gas tank. Do
not remove gas tank.
3. Install new hardware and using existing lever.
(Fig. 1).
Note: Do not over tighten hardware. The
lever must engage and disengage
smoothly (Fig. 1).
4. Retighten gas tank if needed.
Printed in USA
PTO Engagement Kit
Part No. 99–8515
QTY.
2
1
Install engagement kit
1
1
1
1. Hex Head Screw
2. Flat Washer (2)
3. Spacer
The Toro Company – 1998
All Rights Reserved
FORM NO. 3322-276
INSTALLATION
INSTRUCTIONS
USE
1
2
3
6
Figure 1
4. Spring
5. Nut
6. Engagement Lever
4
2
5