Panasonic KX-TDA30 Manual page 41

When Assigning IP Addresses to IP-PTs Without Using a DHCP Server
If you are not using a DHCP server on the network, you will have to set an IP address and subnet mask address
to the IP-PT, in addition to the PBX IP address. If necessary, also enter the IP address of the default gateway.
Follow the procedure below for all IP-PTs on the network, using appropriate IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.2.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
IP-PTs with a multiline display (e.g., KX-NT300 series [except KX-NT321])
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
Select "Network".
IP Address*
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address (if required)
Select "Default Gateway".
To enter the IP address of the IP-EXT card (PBX IP Address)
Return to the
Menu screen.
ENTER
Continued on next page
Press "SETUP" when it is displayed.
ENTER Select "Disable"
for DHCP setting.
1
ENTER
Subnet Mask Address*
ENTER
Default Gateway Address*
ENTER
KX-NT300 with software version 2.00 or later only
Select "PBX". ENTER
PBX IP Address
4.2.1 Assigning the IP Addressing Information
SETUP
Select "IP Address".
2
Select "PBX IP ENTER
Address".
ENTER
Information about IP Proprietary Telephones
ENTER
ENTER
3
ENTER
Select "Primary
PBX".
41