Reassembly - Graco GM3500 Instructions-Parts List Manual

1. Install the clutch housing (2), capscrews (8) and
lockwashers (9) on the engine. Torque the caps-
crews (8) to 200 10 in-lb (23
See Fig. 22.
2. Install the engine shaft key (13). See Fig. 22.
3. Press the clamp (3) onto the engine shaft. Main-
tain the 1.41 0.01 in. (35.8
sion shown in Fig. 23.
4. To check the dimension, place a rigid, straight
steel bar (B) across the face of the clutch housing
(2). Use an accurate measuring device to measure
the distance between the bar and the face of the
clamp. Torque the two screws (16) to
125 10 in-lb (14 1.1 N m
5. Connect the wires of the harness (29) to the
screws (33) in both places on the field. Pull the
plastic caps (C) up and snap them over the
screws. Guide the wires of the harness (29)
through the slot in the clutch housing. Slide the
field (6) into the clutch. Align the setscrew holes in
the field and the clutch housing (2). Tighten the
setscrews (12) oppositely and evenly, to 27
in-lb (3 .33 N m . See Fig. 22.
)
6. Place the engine (1) assembly on the cart. Align
the mounting holes. Guide the engine wire (B) and
wiring harness (29) from the field through the
appropriate grommets (62) in the mounting plate
(E). Install the serrated flange screws (14), and
nuts (48 or 57) and torque to 15
N m). Install the capscrew (15), from under the
engine mounting plate to secure the clutch housing
(2). Connect the engine wire (B) to the red wire
(D), and connect the black and white wires as
shown in Fig. 18.

Reassembly

1.1 N m).
0.254 mm) dimen-
.
)
3
2 ft-lb (20 2.7
Torque oppositely and evenly to
27 3 in-lb (3 .33 N m)
Slot
125 10 in-lb
Torque to
(14 1.1 N m)
Connect wiring harness (29)
here before sliding field (6)
into housing (2)
200 10 in-lb
Torque to
(23 1.1 N m)
12
2
9
8
3
6
16
Fig. 22
2
B
Face of housing
1.41 0.01 in.
(35. 8 0.254 mm)
Torque to
125 10 in-lb
(14 1.1 N m)
Side cutaway view of clutch housing
Fig. 23
13
A
29
33
0049A
16