Panasonic MICRO-IMAGECHECKER A200 Series Hardware Manual page 2

WARNINGS AND CAUTIONS
To be observed at all times
Read the manual carefully before installing, running, maintaining or inspecting the
equipment.
This manual uses two safety flags to indicate different levels of danger.
WARNING
If critical situations that could lead to user's death or serious injury are assumed by
mishandling of the product:
− Do not use this product in areas with inflammable gas. It could lead to an
explosion.
− Exposing this product to excessive heat or open flames could cause damage to
the lithium battery or other electronic parts.
− Do not store a lens in the locations subject to direct sunlight. It could cause smoke
generation.
− Do not look at the sun through a lens. It could cause blindness.
− Always take precautions to ensure the overall safety of your system, so that the
whole system remains safe in the event of failure of this product or other external
factor.
CAUTION
If critical situations that could lead to user injury or only property damage are
assumed by mishandling of the product:
− Do not dismantle or remodel the product. It could cause excessive exothermic
heat or smoke generation.
− Do not touch the terminal while turning on electricity. It could lead to an electric
shock.
− Do not allow foreign matters such as liquid, flammable materials, metals to go into
the inside of the product. It could cause excessive exothermic heat or smoke
generation.
− Do not bend the cables forcibly, place a heavy object on them or bring them close
to a thermal appliance. It could lead to an electric shock or smoke generation.
− To prevent excessive exothermic heat or smoke generation, use this product at
the values less than the maximum of the characteristics and performance that are
assured in these specifications.
− Use the external devices for the emergency stop function and the interlock circuit.
− Connect the wires or connectors securely. The loose connection could cause
excessive exothermic heat or smoke generation.
− Do not undertake construction (such as connection and disconnection) while the
power supply is on. It could lead to an electric shock.