TCS AMI Series Product Information page 7

01/2013
Configuration options*
Function
AS-address
Communication time
Door release time
Door standby time
Programming lock (ON/OFF)
Type of acknowledgement tones
Communication only when door standby active
(ON/OFF)
Light switch function (via door release button of
the indoor stations) ON/OFF
Volume of speech Sprechen
Volume of acknowledgement tones
Send any control function when pressing a bell
button (serial number of the control function =
serial number of ASI11000)
Bell button programming
Send a 16 bit door release command
Door release only when door standby is active
AMI11100 with the configuration software configo™ must be carried out the same way
* The configuration of
as the configuration of ASI11000
Set AS-address
When combining the door loudspeaker module or the display module AMI1010x with a bell
button module AMI1090x the following must be observed:
 The AS-addresses of the built-in door loudspeaker module and bell button module resp.
display module must be the same in order to make a connection.
 Set the AS-addresses to the correct value and place a lock on these addresses.
Bell button programming
Refer to Product information Bell button module AMI1090x.
Set functions
Buttons of a connected bell button module which are not allocated, can be used for switch-
ing functions:
Switching lights via bell button
Send control function
TCS TürControlSysteme AG, TCS Hotline Deutschland: +49 (0) 41 94 / 9 88 11 88
Fax: +49 (0) 41 94 / 9 88 129  E-Mail: hotline@tcsag.de
7
.
Do not programme the button resp. delete programming
Set fnction with device configurator configo
manually TCSK-01
–
x
–
x
–
x
–
x
–
x
–
x
–
x
–
x
–
x
–
x
– –
x x
– –
–
x
TM
configo
x
x
x
x
x
x
x
x
–
–
x
x
x
x
TM
einrichten
Subject to technical changes.
PI_AMI11100-uk 1A