Leds - Cisco Catalyst 9300 Series Hardware Installation Manual

LEDs

The following table lists the optional Cisco Catalyst 9300 uplink network modules. In addition, Cisco Catalyst
9300 Series switches also support 3850 uplink network modules. For the complete list of supported network
modules, see
Table 3: Network Modules
Network Module
C9300-NM-4G
C9300-NM-8X
C9300-NM-2Q
C9300-NM-4M
C9300-NM-2Y
C9300-NM-BLANK
1
For information about the network modules, see the
For cable specifications, see
LEDs
You can use the switch LEDs to monitor switch activity and its performance.
Figure 6: Switch Front Panel LEDs
Note
XPS and S-PWR LEDs are applicable only for C9300 switches.
Cisco Catalyst 9300 Series Switches Hardware Installation Guide
10
Network Modules Overview, on page
1
Description
This module has four 1G SFP module slots. Any combination of standard SFP
modules are supported. SFP+ modules are not supported.
If you insert an SFP+ module in the 1G network module, the SFP+ module does
not operate, and the switch logs an error message.
This module has eight 10G slots with an SFP+ port in each slot. Each port supports
a 1G or 10G connection.
Any combination of SFP and SFP+ modules are supported.
This module has two 40G slots with a QSFP+ connector in each slot.
This module has four Multigigabit (mGig) module slots.
This module has two 25 Gigabit Ethernet SFP28 module slots.
Any combination of SFP, SFP+ and SFP28 modules are supported.
Insert this blank module when the switch has no uplink ports (this is required for
sufficient air flow).
All network modules are hot-swappable.
Cables and Adapters, on page
51.
Installing a Network Module in the Switch, on page
115.
Product Overview
52.