Replacement Procedures
Install an optical disk drive
The following describes the procedure for installing an optical disk drive.
1. Attach the ODD bracket to an optical disk drive and secure it with the following
screws. (See Figure 4-4-2)
• M2.0×3.0 -I(BKAG)(NYLOK) Screw
2.
Insert an optical disk drive assembly into the slot and connect it to the ODD
connector on the system board.
3. Secure the ODD drive with the following screw. (See Figure 4-4-1)
• M2.0×2.0-I-NI(NYLOK) Steel
Figure 4-4-2 Secure the ODD drive with the following screw
4. Assemble the ODD bezel
Satellite L830 Maintenance Manual (960-Q08)
Figure 4-4-3 Assemble the ODD bezel
x2
x1
13