JETWAY IPC Series Technical Manual page 27

ACPI Sleep State
Use this item to select the highest ACPI sleep state the system will enter when the
suspend button is pressed.
The optional settings are: [Suspend Disabled]; [S3 (Suspend to RAM)].
EUP Function
The optional settings: [Disabled]; [Enabled].
This item should be set as [Disabled] if you wish to have all active wake-up
functions.
Wake-Up by PCIE/LAN from S5
The optional settings: [Enabled]; [Disabled].
*This function is supported when EUP Function is set as [Disabled].
Wake-Up by PS/2 Keyboard
The optional settings: [Enabled]; [Disabled].
Use this function to enable or disable PS/2 keyboard wake-up from S3/S4/S5.
*This function is supported when EUP Function is set as [Disabled].
Wake-Up by PS/2 Mouse
The optional settings: [Enabled]; [Disabled].
Use this function to enable or disable PS/2 mouse wake-up from S3/S4/S5.
*This function is supported when EUP Function is set as [Disabled].
PWRON After PWR-Fail
The optional settings are: [Former-Sts]; [Always on]; [Always off].
*This function is supported when EUP Function is set as [Disabled].
RTC WakeUp
The optional settings: [Disabled]; [Fixed Time]; [Dynamic Time].
Use this item to enable or disable system wake on alarm event.
When set as [Fixed Time], system will wake on the hour/min/sec specified.
When set as [Dynamic Time], system will wake on the current time + increased
minute(s).
*This function is supported when EUP Function is set as [Disabled].
 Super I/O Configuration
Press [Enter] to make settings for the following sub-items:
Super IO Configuration
 Serial Port 1 Configuration/Serial Port 2 Configuration/ /Serial Port 3
22