Byron SX-208 Quick Start Manual

Model No. S X-208
Wire Free Traditional Chime Kit
Door C hime Unit
P us h
B utton
Operating
Dis tanc e P us h
100m
B utton Unit
No wiring is required for this Wire Free Door Chime Kit. When the Push Button is pressed, it sends a wire
free signal to the door chime unit that activates the chime. As the operating range is upto 50 metres
(160 ft. approx. - in open field), you can mount or take the door chime virtually anywhere in the home.
However, the transmission range of the wire free signal will be reduced if the signal is transmitted
through a number of walls or ceilings. Metal, and UPVC doorframes will also reduce the operating range.
Push Button Unit
To inset your 1 x 12 volt 23A Lithium batteries (Byron SD-100) .
Inside
looking at
back of the
push
To Replace
The Batteries
Remove the back of the case by Insert 1 x 23A volt battery
pushing in the tab on the bottom (Byron SD100) in the battery
with a small, flat screw driver. compartment, ensuring the
battery polarity matches the
internal markings.
B atteries B atteries
Wire F ree
R equired Included
23A
C C
LR14 LR14
C C
LR14 LR14
100m
80db
Operating Loudnes s
Dis tance
T his
way
up
Using the two holes on the back
of Push Button as a template,
mark the fixing position for the
unit. Drill holes and fit wall plugs
and secure the Push Button unit
with screws (self tapping N3 x
16mm screw).
Door Chime Unit
Battery
Compartment
To reveal the battery compartment, Gently lift the lid up and away from the base. Insert 4 x 1.5 volt
alkaline batteries ("C", LR14 - not included) into the battery compartment, ensuring the battery polarity
matches the internal markings. To replace the cover locate the hole in the lid onto the base. The chime
unit is now ready to use.
To fix your chime to the wall you will find holes in the middle of the base at the top and bottom. First mark
the point of the top hole.
Using the provided screws and wall-plugs, screw the chime to the wall so that the bottom of the chime
swings left and right. You can now align the chime in order that it hangs straight. Mark the bottom hole,
remove the chime from the wall in order that you can prepare the wall for the bottom screw. Now you are
ready to screw your chime to the wall
R T T E
&
appr oved