Invacare Lynx LX-3 Unpacking And Setup Instructions page 5

C. FRONT BASKET INSTALLATION (FIGURE 3)
Check Box When
Completed
1. Remove the front basket from the floor area of the scooter.
2. Remove the packing material that held the basket in place for shipping.
3. Remove the following five (5) items from inside the front basket and set aside for future use:
A. AC Power Cord ( NOTE: This is used for battery charging procedure )
B. Two (2) Anti-Tipper Wheel Assemblies
C. Knob ( NOTE: This is a spare part to be used if a knob is lost )
D. Nut/Bolt ( NOTE: This is ONLY used for the optional flag or cane holder, save for future use if
optional flag or can holder was not purchased. )
To properly install the front basket, perform the following steps:
Check Box When
Completed
1. Align the slots of the front basket with the mounting clips located on the front of the tiller (FIGURE 3).
2. Push down on the front basket to secure it in place.
Front Basket
Slots
FIGURE 3 - FRONT BASKET INSTALLATION
5
FRONT BASKET INSTALLATION
Shroud
Of Tiller
Mounting Clips