Bleeding The Fuel System; Maintenance - Stiga TITAN 26 B Instructions For Use Manual

EN
Reduce the speed on slopes and when
making sharp turns to prevent the
machine from tipping over or you
losing control.
Do not turn the steering wheel to full
lock when driving in top gear and at full
throttle. The machine can easily topple
over.
Keep hands and fingers well away from
the articulated steering joint and seat
bracket. Risk of crushing injuries.
Never drive with the engine casing
open.
5.11 STOP
Disengage PTO. Apply the parking brake.
Allow the engine to idle 1 - 2 mins. Stop the engine
by turning off the starter key.
If the machine is left unattended,
remove the ignition key.
The engine may be very hot
immediately after it is shut off. Do not
touch the silencer or other engine parts.
This can cause burn injuries.

5.12BLEEDING THE FUEL SYSTEM

(26B, 26H)
If there is air in the fuel system, this must be bled
manually. Air may have entered due to the follow-
ing:
• After stopping due to lack of fuel.
• After replacing the filter.
• After draining the water separator.
• After carrying out repairs in the fuel system.
Never attempt to carry out bleeding by
turning the engine with the starter
motor. This will damage the starter
motor.
Bleed as follows:
1. Check that the fuel tank is filled.
2. Open all taps in the fuel system.
3. Pump using the control (7:V) until all air has
been pumped out of the fuel system.
4. Attempt to start. If the engine does not start,
continue bleeding as above.
5.13 CLEANING
To reduce the risk of fire, keep the
engine, silencer, battery and fuel tank
free from grass, leaves and oil.
To reduce the risk of fire, regularly
check the machine for oil and/or fuel
leakage.
Never use high-pressure water. This can
damage shaft seals, electrical
components or hydraulic valves.
90
ENGLISH
Never use high-pressure air against the
radiator fins. This will damage the fin
structure.
Clean the machine after use. The following in-
structions apply to cleaning:
• Do not point jets of water directly at the engine.
• Clean the engine with a brush and/or com-
pressed air.
• 26H, 32H:Disconnect and fold down the oil
cooler according to fig. 14.
Clean the engine's radiator (13:D) and oil cool-
er (13:E) with a soft brush. Large objects can be
removed by hand. If the coolers are heavily
soiled, clean using slow running water and a
suitable detergent.
26H, 32H: Reinstall the oil cooler according to
fig. 14.
• After cleaning with water, start the machine and
any cutting deck to remove the water that may
otherwise penetrate bearings and cause

6 MAINTENANCE

6.1 SERVICE PROGRAM
In order to keep the machine in good condition, as
regards reliability and operational safety as well as
from an environmental perspective, the service in-
structions in this section should be followed.
All services should be carried out by authorised
workshops.
Service, carried out by authorised workshops,
guarantees a professional job with original re-
placement parts.
The service log should be stamped at every service
carried out by an authorised workshop. A "fully
stamped" service log is a valuable document that
improves the machine's second-hand value.
The service points are given in the table below. De-
scriptions of how the procedures are to be carried
out are given after the table.
damage.