Table of Contents
Advertisement
6.2
Switching the server on and off
CAUTION!
If nothing appears on the screen but flickering stripes after switching
●
on the server, switch the server off immediately (see chapter
"Troubleshooting and tips" on page
Power button does not disconnect the server from the mains voltage.
●
To completely disconnect it from the mains voltage, remove the power
plugs from the sockets.
Do not move, strike, or shake the server when it is turned on. This can
●
damage the hard disk in the server and cause data loss.
Turn the server on when the temperature is in its operating
●
environment range (5 - 40°C). For details on the operating
environment, refer to "Safety Precautions". When operating the
device outside of this operating environment, the server may operate
improperly, damage data etc. Furthermore, Cisco cannot be held
responsible for any related damage, malfunction, or loss of data, etc.
Be sure to wait for 10 seconds or more after shutdown before turning
●
the server on.
After connecting the power cords, press Power button after it passes
●
for more than 10 seconds.
Switching the server on
AC-connected indicator (see
mode) when the server is connected to the mains.
Starting up for the first time:
Press Power button (see
Follow the on-screen instructions (see also section
and installing the operating system" on page
60
Figure 6.2 on page
Figure 6.2 on page
Cisco C880 M5 Installation Manual
77).
47) lights up green (standby
47).
"Configuring the server
71).
Advertisement
Table of Contents
