Table of Contents
Advertisement
CD Check the film position.
• Confirm that the film edges are precisely
between the two film guide rails. Also
confirm that the film perforations mate with
the drive sprockets.
• Adjust the position of the film cartridge to
make its mouth level with the film plane.
® Close the rear cover. Press the rear cover until it clicks.
• The dark box is different from a standard single lens reflex camera. Therefore,
do not tum the film rewind knob of the dark box to take up the film slack before
initial film advance. If you do so, the film tip may shift from the index mark and
affect correct film advance.
® Initially advance the film.
Touch the WIND key of the control box once to automatically advance the film
until the frame counter of the dark box indicates "1 ". This, however, is possible
only when the dark box is connected to the microscope base with the DX cable. If
the DX cable is not connected to the dark box, keep touching the WIND key until
the film counter indicates "1 ".
• The film advance indicator of the dark box rotates while the film is being
advanced correctly. If it does not, re-load the film correctly.
• Confirm that the film end LED of the control box is not lighting. If this LED is
lighting, touch the WIND key again to complete the initial film advance.
Pc:-::7
��
/
�}
/
�
FX-35DX
□� �
Nikon
NFx-
NFX-35
-c
::c
0
s::
i'i
:,J
0
G>
:,J
)>
48
Hide quick links:
Advertisement
Table of Contents
