Usb Connector (Usb-B) - Kenwood TS-890S In-Depth Manual

terminal FUnCtiOnS 10

USB Connector (USB-B)

This connector is used for connecting a PC. It supports the use of the ARCP-890 for remote control of the TS-890S as
well as input and output of TX and RX audio to and from the PC using the USB Audio feature. It can also be used for
updating the firmware (firmware update can also be performed using a USB flash drive).
A USB cable conforming to USB2.0 (A connector to B connector type) must be used.
Two USB keying features have also been added on the TS-890S. (For more details, refer to "USB Keying Feature".)
The internal configuration within the USB-B connector of the TS-890S is shown below.
Fig. 81 Block Diagram of USB Connector (Rear Panel) Peripherals
81