Kns Operation Without Using The Host Pc - Kenwood TS-890S In-Depth Manual

Software 09

KNS Operation without using the Host PC

For the TS-890S series, the remote control through a LAN or the Internet is available by using the radio control program
ARCP-890 and KENWOOD NETWORK COMMAND SYSTEM (KNS).
Fig. 70 Remote Control through the Internet
Fig. 71 ARCP-890
In the KNS operation, the control command data communication and the audio data communication are done between
the TS-890S and ARCP-890 by using a LAN or the Internet. The audio data communication is done with the VoIP
function available in the TS-890S and ARCP-890, and the received audio of the TS-890S can be heard from a PC
speaker. The audio input from a PC microphone can also be sent from the TS-890S.
Displaying the bandscope on the ARCP-890 is also possible. The bandscope with a display speed equal to or higher
than that of the TS-890S can also be used on the ARCP-890.
In this bandscope screen, the ratio of the spectrum scope display to the waterfall display can freely be changed. Also,
the same operation as touch tuning of the main unit by clicking the mouse (left-clicking: short-press touch, right-clicking:
long-press touch) can be done.
Fig. 72 Bandscope Display on the ARCP-890
65