100| The Editor
Total FX section
Here you can adjust the settings of a final limiter inserted at the end of the
audio signal. Please note that this section is not available from the SV2 front
panel. This is the only place where you can edit it.
Choosing a Total FX effect
Click the name of the selected Total FX model, then choose a different item
from the list.
Stereo Limiter
The limiter regulates the output signal level. It is similar to a compressor, ex
cept that the limiter compresses only signals that exceed the specified level
to lower unnecessary peak signals.
Parameters
Ratio
Threshold
Attack
Release
Gain
Values
Notes
1.0 : 1 ... Inf : 1
Sets the signal compression ratio. Compression is ap
plied only when the signal level exceeds the Threshold
value.
40...0 dB
Sets the level above which the compressor is applied.
1...100 [ms]
Sets the attack time. A higher attack time will cause the
compression to be applied more slowly, and not react
fast enough for louder notes.
1...100 [ms]
Sets the release time. A higher release time will cause
the compression to be released more slowly; this may
cause the cue of some softer notes to be cut.
Inf, 38...+24
Sets the output gain. Use it to compensate for the gain
dB
loss caused by compression.