Inspection; Setting Up And Using The Kit; Preparing The Kit - Intel PXA27 Series Quick Start Manual

1.5

Inspection

After unpacking the kit, verify that you have all the items listed in
for visible damage. Other areas you must inspect include:
•
Cable connectors, check to make sure that there are no bent or damaged pins.
•
Standoffs, make sure they are tight.
•
Standoff screws, make sure that they are snug.
If any item is damaged, return the item to Intel. If you need to return any items to Intel, please send
an e-mail to:
the subject line of the e-mail.
2.0

Setting Up and Using the Kit

There are two general steps and one optional step you should follow when setting up and using
your kit. These general steps are:
1.

"Preparing the Kit"

2. "Testing the Kit"
3. (optionally)
2.1 Preparing the Kit
Follow these steps to set up your kit:
1. Unfasten the two flexible tie straps, one on each side of the platform. (These straps secured the
platform during shipment and storage.)
2. Raise the platform panel to a comfortable viewing and operating position.
3. Connect the AC power cord to the power supply; plug the power cord into a power outlet.
During setup and while starting kit, refer to the following
®
Intel PXA27x Processor Developer's Kit -Quick Start Guide
PCAdevbdRMA@mailbox.intel.com
"Troubleshooting the Kit"
Section 1.1. Inspect each item
for an RMA request. Type "Board Issues" in
Figure 1:
7