Table of Contents
Advertisement
2. INSTALLATION. HOW DO I INSTALL THE TV COMBI?
Important for the United Kingdom
This apparatus is fitted with an approved moulded
13 Amp plug. To change a fuse in this type of plug
proceed as follows:
1
Remove fuse cover and fuse.
2
Fix new fuse which should be a BS1362 5A,
A.S.T.A. or BSI approved type.
3
Refit the fuse cover.
If the fitted plug is not suitable for your socket
outlets, it should be cut off and an appropriate plug
fitted in its place.
If the mains plug contains a fuse, this should have a
value of 5A. If a plug without a fuse is used, the fuse
at the distribution board should not be greater than
5A.
Note: * The severed plug must be destroyed to
avoid a possible shock hazard should it be
inserted into a 13A socket elsewhere.
How to connect a plug:
The wires in the mains lead are coloured in accor-
dance with the following code:
BLUE - 'NEUTRAL' ('N')
BROWN - 'LIVE' ('L')
1
The BLUE wire must be connected to the termi-
nal which is marked with the letter 'N' or
coloured BLACK.
2
The BROWN wire must be connected to the
terminal which is marked with the letter 'L' or
coloured RED.
3
Do not connect either wires to the earth terminal
in the plug which is marked with the letter 'E' or
by the safety earth symbol
green or green-and-yellow.
Before replacing the plug cover, make certain that
the cord grip is clamped over the sheath of the lead -
not simply over the two wires.
4
\
or coloured
How to insert the batteries into the
remote control
1
Remove the battery compartment from the back
of the remote control.
2
Insert the batteries as indicated into the battery
compartment.
3
Close the battery compartment.
Note:
* For the remote control to function properly,
you must always point it directly at the set.
Hide quick links:
Advertisement
Table of Contents
