Parameters Definitions - Omron E5AK-AA2-500 Manual

E5 K

PARAMETERS DEFINITIONS

Refer to your User's Manual for each parameter and the calibration mode in detail.
Level 0 Mode for E5AK and E5EK
  






  


 


Level 0 Mode for E5CK
PV/SV
  
The process value is displayed on the No.1 display and the set point is displayed on the No.2 display.

When the multi-SP function is in use, the value of the current set point (SP0 or SP1 is displayed).
Set Point During SP Ramp

Monitors the set point when the SP ramp function is used.

Manipulated Variable (MV) Monitor for Heat

Monitors the manipulated variable (MV) for the heating output.


Manipulated Variable (MV) Monitor for Cool
  
When the Controller is in heating and cooling control operation, use this display to monitor the manipulated


variable of the cooling output.
Run/Stop
 

Places the controller in RUN mode or in STOP mode.

PV/SV
The process value is displayed on the No.1 display and the set point is displayed
on the No.2 display. When the multi-SP function is in use, the value of the current
set point (SP0 or SPD is displayed).
Set Point During SP Ramp
Monitors the set point when the SP ramp function is used.


For E5 K-
Manipulated Variable (MV) Monitor for Heat
PRR2
Monitors the manipulated variable (MV) for the heating output.

Valve Opening Monitor

Displays the valve position in percentage format.
Open = 100%
Closed = 0%
Manipulated Variable (MV) Monitor for Cool
When the Controller is in heating and cooling control operation, use this
display to monitor the manipulated variable of the cooling output.
Run/Stop
Places the controller in RUN mode or in STOP mode.
E5 K