Panasonic EP3513-U1 Servise Manual page 15

EP3513
4. Remove the Connecting cord for the power source from the
Massage block cover clip.
* When removing the Massage mechanism block, use the special
tool (WEP000S8967) if you cannot lean the Massage lounger
forward
* Use the special tool at only left side, because it may damage
the Sensor board located at right side if you use the tool on the
right side
5. Unscrew four screws on the Rail piece set left and remove the
Rail piece set left and install the special tool.
Caution
- If the Massage mechanism block may fall down, hold it by
your hand.
6. Unscrew four screws on the Rail piece set right and remove the
Rail piece set right.
Caution
If the Massage mechanism block may fall down, hold it by your
hand.
- 15 -
ORDER NO.HPD0509U24C1