Installation - Wells H33 Owner's Manual

INSTALLATION

NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
CAUTION:
ELECTRIC SHOCK
HAZARD
The ground prong of the
power cord is part of a
system designed to protect
you from electric shock
in the event of internal
damage to the appliance.
NEVER CUT OFF THE
GROUND PRONG (large
round prong). NEVER
TWIST A PRONG TO FIT
AN EXISTING
RECEPTACLE.
Contact a licensed
electrician to install an
electrical receptacle
appropriate to the voltage
and amperage requirements
of the hotplate.
IMPORTANT:
Damage due to being plugged
into the wrong voltage or
phase is NOT covered by
Warranty.
UNPACKING & INSPECTION
Carefully remove the hotplate from the carton. Remove all protective
plastic film, packing materials and accessories from the hotplate
before plugging the hotplate into electrical power or otherwise
performing any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the hotplate before starting any
installation.
Read and understand all labels and diagrams attached to the hotplate.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
SETUP
Supplied legs must be properly installed.
Setup the hotplate only on a firm level surface. Non-combustible
material (e.g. metal, terrazzo) is recommended.
Maintain at least 1" from adjacent surfaces.
ELECTRICAL
Refer to the nameplate. Verify the electrical service power. Voltage
and phase must match the nameplate specifications. Connecting the
hotplate to the wrong voltage can severely damage the equipment or
cause noticeably decreased performance.
If your hotplate is equipped with a grounded electric power cord, this
cord must be plugged into a properly grounded electrical receptacle.
If your hotplate is not supplied with a cordset, the hotplate must be
installed by a licensed electrician in accordance with all applicable
codes and ordinances.
4