Kohler K-4026 Installation Manual page 8

Flexible
Hose
Pump Wiring
Harness
Level Switch
Wire
Refill Tube
Electrical Plug
5. Install the Collar
CAUTION: Risk of product damage. Confirm the wires and water supply hose will not interfere with the
vitreous shell as it is lowered into place. The vitreous shell may cause damage to the wires or hose.
NOTE: It may be necessary to disconnect the water supply hose and tape it to the floor with the wires to
keep it clear of the vitreous while it is lowered into place.
Place the pump wiring harness, level switch wire, refill tube, electrical plug, and bidet wiring plug
on the floor at the location of the rear access opening and tape them on the centerline so they will
not interfere with the vitreous shell.
Apply silicone grease or soap to the inside bottom edges of the collar where it will contact the outlet
gasket.
Install the collar onto the outlet gasket. Push the collar down firmly.
Clip the spray shield into place over the fill valve.
1221754-2-C
Tape
Bidet Wiring
Harness
8
Collar
Apply silicone grease
or soap to the inside.
Spray Shield
Tank
Kohler Co.