Prepare And Do Servicing On The Product; Maintenance Schedule; Assembly - Husqvarna 324L Workshop Manual

3 Prepare and do servicing on the product

3.1 Maintenance schedule

Maintenance
Clean the external surface.
Clean the muffler, exhaust pipe and engine from leaves, dirt and unwanted lubri-
cant.
Make sure that the cutting attachment does not move at idle speed.
Do a check of the stop switch.
Examine the cutting attachment and the cutting attachment guard for damages
and cracks. Replace if it is damaged.
Examine the hand guard for damages and cracks. Replace if it is damaged.
Make sure that the handles are installed correctly and are not damaged.
Do a check of the throttle trigger lockout and the throttle trigger.
Examine the engine, the fuel tank and the fuel lines for leaks.
Tighten nuts and screws.
Examine the fuel filter for contamination and the fuel hose for cracks and other
defects. Replace the parts if it is necessary.
Do a check of the engine oil level. Fill with oil if it is necessary.
Examine the starter and the starter rope for damages.
Clean the air filter. Replace if it is necessary.
Examine the vibration damping units for damages and cracks.
Examine the spark plug.
Clean the cooling system.
Clean the external surface of the carburetor and the area around it.
Clean the spark arrester screen. Replace the spark arrester screen if it is neces-
sary.
Clean the inner surface of the fuel tank.
Examine the spark plug. Replace the spark plug if it is necessary.
Do a check of all cables and connections.
Make sure that the bevel gear is filled with grease.
Do a check of the clutch assembly and the clutch drum for wear. Replace the
parts if it is necessary.
Do an oil change.

3.2 Assembly

WARNING: Read and understand the safety
chapter before you assemble the product.
6 - Prepare and do servicing on the
product
Before After 100
After 40 h
operation
After each operation.
After each operation.
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
1218 - 001 - 01.07.2019
h
X
X
X
X
X
X
X