APRILIA RSV mile Use & Maintenance Book page 141

HIGH BEAM BULB (ONE UPPER RIGHT
POSITION, ONE UPPER LEFT POSITION)
NOTE
Remove the bulb electric con-
nectors one by one in such a way as to avoid
replacing them incorrectly during reassem-
bly.
If the bulb electric connectors must all be
removed at the same time, mark the bulb
electric connectors and take great care to
reassemble them in the proper position.
◆
Remove the front part of the fairing com-
pletely, see p. 117 (REMOVING THE
FRONT PART OF THE FAIRING).
For the right high beam bulb only:
Working from the right side of the rear part
of the fairing.
For the left high beam bulb only:
Working from the left side of the rear part of
the fairing.
8 9
◆
Pull back the rubber boot (8) with your
fingers.
To extract the bulb electric connector,
do not pull its electric wires.
◆
Grasp the bulb electric connector (9) pull
it and disconnect it from the bulb (2).
◆
Release the two ends of the clip (10) po-
sitioned at the rear of the bulb socket
(11).
◆
Remove the bulb (2) from the seat.
NOTE
Be sure to maintain the same
orientation as the old bulb when you install
the new bulb. Do not try to force the bulb, it
will go easily if it is properly oriented.
◆
Correctly install the new bulb into its soc-
ket (11), ensuring that the tabs (A) are
correctly positioned.
◆
Replace the two ends of the clip (10) in
them seat.
A
10
11
◆
Connect the bulb electric connector (9).
◆
Replace the rubber boot (8) with the ca-
ble passage downwards.
◆
Replace the front part of the fairing com-
pletely, see p. 117 (REMOVING THE
FRONT PART OF THE FAIRING).
use and maintenance RSV mille
A
! - !
141
RSV mille R