Finishing Requirements - Lennox ADAGIO-MN Installation Instructions Manual

Figure 53 - Burner Flame Appearance
f i r e - p a r t s . c o m
30
FINISHING REQUIREMENTS - Wall Details
Complete finished interior wall. To install the appliance facing flush with
the finished wall, position framework to accommodate the thickness of
the finished wall (Figure 54).
IMPORTANT NOTE:
Place the header verti-
cal as shown to main-
tain proper clearance
from the vent system to
combustibles.
* Vent to combustible
on Side = 1" Min.
Vent to combustible
on Top = 3" Min.
u
4" clearance is required above the elbow for installations that require an
elbow at the top of the unit and that ends in a horizontal termination.
Figure 54
Hearth Extension
A hearth extension is not required with this appliance. If a hearth extension
is used, do not block the lower control compartment panel. Any hearth
extension used is for appearance only and does not have to conform to
standard hearth extension installation requirements.
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Header
(2x4)
4" Min
Drywall
(102 mm)*
1" Min.
(25 mm)*
Top of
Appliance
Spacers
Fireplace (right side)
�