Flush Mixed Material - Graco XM Series Installation-Parts

Plural-component oem sprayer

Hide thumbs Also See for XM Series:

Table of Contents

Enlarged version

Flush Mixed Material

Flush Mix Manifold

Use Solvent Pump

1. Press Stop

to turn off system. Engage trigger

lock. Remove spray tip.

2. Ensure sampling valves (AE, AF) and mix manifold

valves (AH, AJ) are closed.

3. Open solvent shutoff valve (AK) at mix manifold.

4. Open solvent pump air valve (CB). Pull out and

slowly turn solvent pump air regulator (CG)

clockwise to increase air pressure. Use lowest

possible pressure.

5. Disengage trigger lock and trigger gun into a

grounded pail. Use a pail lid with a hole to dispense

through. Seal around hole and gun with a rag to

prevent splash back. Be careful to keep fingers

away from front of gun. Flush out mixed material

until clean solvent dispenses.

6. Close solvent pump air valve (CB) and solvent

shutoff valve (AK) at mix manifold. Trigger spray

gun to relieve pressure.

7. Engage trigger lock.

8. Disassemble and clean spray tip with solvent by

hand. Reinstall on gun.

ti1950a

ti1949a

ti1953a

313292J

Table of Contents